Mitsubishi Heavy Industries FDT125VF/FDC125VS 12.5KW 43,000btu (3 PHASE) Micro Inverter Cassette System
Please see attached photo for technical specification.
Individual flap control system
According to room temperature conditions, four
directions of air flow can be controlled individually by
following Flap control system.
As individual flap control is available even after
installation, installation area became wider than before.
Due to optimization of outlet design of air flow with our
new advanced technology, sufficient air flow is secured
and long reach of air flow is realized.
Flap control system
The flap can swing within the range of upper and
lower flap position selected with wired remote control.
(this system is applied for FDEN, SRK type also)
* Wireless remote control and RCH-E3 is not applicable to the Individual flap
control system and the Flap control system.
The thinnest design
Thanks to new design of heat exchanger changed from 2 parts to 1 part, the height of
indoor unit is reduced drastically.
High efficiency
• Reduction of air flow pressure loss
Expansion of outlet air flow area realizes
reduction of pressure loss caused by air flow
in the indoor unit. Load of fan motor is
decreased and efficiency is increased.
• Increase of heat transfer efficiency
Applying high efficient piping in heat exchanger and
optimization of heat exchanger (2parts ► 1part)
increases heat transfer efficiency.